Please check the following:

Is the power cord or plug damaged?

Check other household appliances.

Check the light in another socket.

Ensure the jack plug is inserted by threading through the clamp.

Push the jack plug into the base.

Ensure the light is plugged into a wall socket and switched on.

Press the power button to switch on.

Hold the switch down to use the dimmer switch.

Check that the wheel carriage plates are screwed together currently.

Disconnect the carriage plates

Ensure the light is at the top before carrying out the checks. Failure to do this will cause the weight to drop.

Use Hex key provided to remove the three screws.

Be careful to capture all screws when they are loosened.

Hold the heat sink at all times when removing from the upright.

Ensure the red tape on the plates covering the contacts has been removed.

Reassemble the carriage plates

Align the square shapes and screw holes on the heat sink arm and the upright.

Press the two parts together with one hand.

Loosely screw in the three screws.

Recheck alignment.

Proceed to screw until securely clamped.

Unplug the light and leave for 5 minutes.

Plug the light in and switch on.

Check that the wheel carriage plates are screwed together currently.

Disconnect the carriage plates

Ensure the following before starting the checks.

Ensure the light is at the top before carrying out the checks. Failure to do this will cause the weight to drop.

Use Hex key provided to remove the three screws.

Be careful to capture all screws when they are loosened.

Hold the heat sink at all times when removing from the upright.

Ensure the red tape on the plates covering the contacts has been removed.

Reassemble the carriage plates

Align the square shapes and screw holes on the heat sink arm and the upright.

Press the two parts together with one hand.

Loosely screw in the three screws.

Recheck alignment and proceed to screw until securely clamped.

Check electrical supply

Please check the following:

Is the power cord or plug damaged?

Check other household appliances.

Check the light in another socket.

Check power cord

Ensure the jack plug is inserted by threading through the clamp.

Push the jack plug into the base.

Ensure the light is plugged into a wall socket and switched on.

Check the dimmer switch

Press the power button to switch on.

Hold the switch down to use the dimmer switch.

Check wheel carriage plates

Check that the wheel carriage plates are screwed together currently.

Follow the procedure image for correct assembly.

Disconnect the carriage plates

Ensure the light is at the top before carrying out the checks. Failure to do this will cause the weight to drop.

Use Hex key provided to remove the three screws.

Be careful to capture all screws when they are loosened.

Hold the heat sink at all times when removing from the upright.

Ensure the red tape on the plates covering the contacts has been removed.

Align the square shapes and screw holes on the heat sink arm and the upright.

Press the two parts together with one hand.

Loosely screw in the three screws.

Recheck alignment.

Proceed to screw until securely clamped.

How to assemble your Dyson light

Thread the jack plug through the clamp.

Remove tape from the upright.

Push the clamp up onto the upright.

Push the jack plug into the base.

Remove the red tape from the mounting plates to expose the electrical contacts.

Remove red tape on detachable arm.

Align the squares and screw holes on the heat sink arm and the upright.

Press the two parts together with one hand.

Attach the heat sink arm

Loosely screw in the three screws.

Recheck alignment.

Proceed to screw until securely clamped.

How to use the dimmer

Press the power button to switch on.

Hold the switch down to use the dimmer switch.

How to reposition the Dyson light

The LED head can be positioned directionally in 3 axes.

Only use the heat sink arm to reposition.

Please follow the steps in the video.

CSYS Clamp user guide